Torque Specs For Thermostat Housing Opportunity

July 8, 2024, 8:35 pm
There is no Loctite on intake bolts. I have enough breaker bars. Volvo now recommends Wurst super silicone for those applications and gaskets and or gasketless surfaces such as the transmission valve body cover and other places. Install the thermostat housing cover. Thanks again1965 Tempest Chassis Shop Manual pg 6A-10 staes 20-35 ft-lb for V8. Torque for 92 5sp 1.0L engine coolant thermostat housing bolts needed. Join Date: Aug 2010. They're not as accurate at the low torque settings. If you are working on a 3. Does anyone have the torque specs for the 2 thermostat bolts? 1990 4runner 4wd Auto V6. That's like screwdriver level.

Thermostat Housing Torque Specs Chevy

All you are doing is pushing the new gasket between 2 pieces of metal. I have search but cannot seem to find the torque specification for the thermostat housing for a 1965 GTO. If you use an impact for everything,.. that explains a lot Never said I use an impact for everything,.... 7 posts • Page 1 of 1. Rear Suspension & Brake. Then the lower housing cracked at a torque of less than 15 ft-lbs.

Torque Specs For Thermostat Housing Bubble

Just use your hands. I've got the new water pump installed. This a common procedure on many make/model cars. Just look up a standard torque spec for the size bolts. See Fel-pros' web for more information. Save a life, adopt a senior shelter pet. Questions: 1) What is the proper torque value for the thermostat screws?

Thermostat Housing Torque Specs

Anybody know what the correct torque is supposed to be on the bolts for the thermostat cover? Last edited by therza; 02-06-2010 at 10:50 AM. You go ten Nm over on one of those small thermostat screws, and I would think it couldn't help but break. As for RTV, I tend to only use it where the manual calls for it. 2) What is the consensus among our group regarding the water pump stall dry or with sealant? 1993 Nissan 300zx Twin Turbo. Maybe a little less if you are using a cork gasket and I would glue the gasket to the housing with gasket sealer real good before installing it. Why would aftermarket ones follow Volvo procedures? Snug, and then a little more is good enuf. What's the right torque for thermostat housing bolts. And I've never broken one or seen a co-worker break one. In fact in the "theory" section it does in fact mention that the removal / re-installation process on an unclean engine can in fact cut O-Rings and for that reason they are to be used once.

254K - Y2K/E - Clock still works. Interesting, I'm going to have to go check out HF. But in that case, I stopped there. Not with 3 new bolts, no way. Oh this is for a 360 and intake is a Victor 340.

Erica Banks Before Plastic Surgery